User Tools

Site Tools


k_r_chapter_7

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
k_r_chapter_7 [2019/05/13 14:58]
hutch
k_r_chapter_7 [2019/05/13 14:58]
hutch
Line 4: Line 4:
  
 UNLESS SPECIFIED, DON'T USE THE XILINX SDK AS IT IS CONFIGURED TO USE A C++ COMPILER SO THAT IT WILL COMPILE FILES PORTED FROM ARDUINO C++ FILES FOR THE DISPLAY AND TOUCH CONTROLLER. Use [[http://​rextester.com/​l/​c_online_compiler_gcc|rextester]]. When using rextester, you can paste the code of interest directly into the rextester window. Or, if you want to use gcc on your PC, you can use the instructions embedded in the comments of the file shown below. UNLESS SPECIFIED, DON'T USE THE XILINX SDK AS IT IS CONFIGURED TO USE A C++ COMPILER SO THAT IT WILL COMPILE FILES PORTED FROM ARDUINO C++ FILES FOR THE DISPLAY AND TOUCH CONTROLLER. Use [[http://​rextester.com/​l/​c_online_compiler_gcc|rextester]]. When using rextester, you can paste the code of interest directly into the rextester window. Or, if you want to use gcc on your PC, you can use the instructions embedded in the comments of the file shown below.
- 
-<code C ch7_studyQuestions.c>​ 
  
   * (T or F) The value for EOF is typically -1.   * (T or F) The value for EOF is typically -1.
Line 23: Line 21:
 </​code>​ </​code>​
  
-prints out hello there! when executed.+prints out hello there! when executed ​(T or F).
  
   * (T or F) sscanf() reads characters from standard input.   * (T or F) sscanf() reads characters from standard input.
k_r_chapter_7.txt ยท Last modified: 2019/05/13 14:58 by hutch